BETCO PB24-11 Manuel de l'opérateur télécharger pdf (Page 10)

STARTING AND STOPPING

THE HONDA ENGINE

STARTING THE HONDA ENGINE

The Honda engine is equipped with a 110 volt AC starter.

1) Install tank.

2) Attach propane hose coupling and fully tighten.

3) Tilt machine back so that pad is off the floor.

4) Open propane tank valve (turn counterclockwise). Hose will fill.

Must not be any leaks.

5) Put throttle cable into the “fast” position.

6) Hook cord to starter connection and plug into wall outlet.

7) Push red start button and hold until the engine starts. Do not

crank for more than 20 seconds at a time and wait at least one

minute between tries when cranking. See troubleshooting guide if

the engine does not start after several tries.

8) After engine starts, unplug cord and return to storage position on

handle.

9) Set throttle to a slow operating speed until the motor warms up.

Can increase engine speed after 3 to 5 minutes.

STOPPING THE HONDA ENGINE

1) Turn propane tank valve to the closed position (turn clockwise)

and allow the engine to continue running until it runs out of fuel.

BETCO, CORP. 7/26/07 Page 10 PROPANE BURNISHER

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Pas de commentaire

BETCO PB24-11 Manuel de l'opérateur Page 10